Attaching Ground Wires For Purchased Ground Blocks; Connecting Power To The Branch Gateway - Avaya G450 Quick Start For Hardware Installation

Power up
Danger:
Failure to install both grounds will void the Product Safety certifications (UL and the CE
Mark) on the product, as well as allow a hazard to be present that could result in death or
severe personal injury.

Attaching ground wires for purchased ground blocks

1. Cut the Supplementary Ground Conductor (which has one end attached to the
2. Attach one end of the remaining 10 AWG (4 mm
3. Cut this ground wire to the length needed to reach the approved ground.
Result
Note:
The ground block is for use with more than one Branch Gateway in the rack. If the ground
block is to be used, you must supply it and have it installed by an electrician.

Connecting power to the Branch Gateway

After you have mounted the Branch Gateway, installed the PSU(s), installed the media
modules, and attached grounding conductors, you can connect power to the Branch Gateway.
The Branch Gateway can be ordered with either one or two power supply units.
1. Connect the power cable to the power connector on the Branch Gateway back
2. Plug the power cable into an AC outlet.
34 Quick Start for Hardware Installation: Avaya G450 Branch Gateway
grounding screw on the chassis) to the length needed to terminate it into one of the
terminals of the ground block.
Do not coil the Supplementary Ground Conductor.
in the ground block and the other end to an approved ground.
Do not coil this wire.
panel.
The Branch Gateway is now powered.
2
) ground wire to one of the terminals
February 2011