Attaching A Mounting Bracket To The Middle Of The Branch Gateway; Brackets With Cable Guides - Avaya G450 Quick Start For Hardware Installation

Attaching a mounting bracket to the middle of the Branch Gateway

Brackets with cable guides

You can attach the mounting bracket with cable guides to the front of the Branch Gateway on
one side, as shown in the following figure. If you are fastening the chassis to the rack at the
front, use the mounting bracket with cable guides as one of the two front brackets. If you are
fastening the chassis to the rack at the middle, use the mounting bracket with cable guides at
the front of the chassis, in addition to the two regular mounting brackets on the sides of the
chassis. In this case, the mounting bracket with cable guides serves for cable management
only — you do not fasten it to the rack.
Note:
It is recommended to attach the mounting bracket with cable guides to the left side of the
rack, so that the cables will not interfere in the event that you replace the fan tray. However,
iIf you are installing an MM717 or MM716 media module, attach the mounting bracket with
cable guides to the right side of the rack, to support the weight of the amphenol cable you
will connect to the MM717 or MM716 media module. See
an MM712 or MM717 media
Note:
Connecting a DCP telephone to an MM712 or MM717 media module
Quick Start for Hardware Installation: Avaya G450 Branch Gateway
module.
Mounting the Branch Gateway chassis
Connecting a DCP telephone to
February 2011 21