Avaya G450 Quick Start For Hardware Installation page 25

Figure 1: Attaching a bracket to each side of the Branch Gateway
Fastening the Branch Gateway to the wall
Note:
The plywood and the hardware to mount the plywood are customer-provided.
1. If the wall does not have a portion of plywood available, mount a plywood sheet at
2. Mark the plywood with the location of the Branch Gateway bracket screw holes
3. Position the Branch Gateway so that its front panel is facing up, and secure it to the
Quick Start for Hardware Installation: Avaya G450 Branch Gateway
least ¾ in (2.0 cm) thick and at least 4 x 4 ft (1.2 x 1.2 m) in size, horizontally onto
the wall.
Make sure the plywood is sufficiently anchored in the wall. Use a minimum of four
wood screws and ensure the screws are driven into wall studs, or use four wall
anchors rated not less than 50 pounds (22.5 kg) shear strength each.
before fastening the plywood to the wall.
plywood using a minimum of four screws (pan head at least ¾ in, #10-12 screw).
Mounting the Branch Gateway chassis
February 2011 25