Setting The Event - Samsung XRN-1610S User Manual

SettIng the eVent

You can make the setup for record in case of sensor detection, camera event or video loss detection.
Sensor Detection
You can set the sensor's operating condition and connected camera, as well as alarm output and its duration.
• Apply to other sensors : If you select <Apply to other sensors>, the "Apply to other sensors" confirmation
window will appear.
After selecting channels that the settings will be applied to, click on <OK> to apply them to the selected
channels.
• Sensor Operation : Sets the operation mode of sensors.
In the <Camera> tab, you can set whether or not to use a sensor.
`
- <n.O (normal Open)> : Sensor is opened. If the sensor is closed, it generates alarm.
- <n.C (normal Close)> : Sensor is closed. If the sensor is open, it generates alarm.
• Cam : Select a channel to be connected to the sensor.
If selected camera, "Cam preset setup" window appears.
Select a channel and setup the preset.
Preset setup can be done in PTZ mode.
`
• Alarm out : Sets the alarm output method.
For further information on alarm output, refer to "HDD Alarm > Alarm". (Page 39)
`
• Duration : Sets the duration of alarm signal and alarm sound.
If you select <Camera> tab, you can configure the sensor operation settings of the network camera connected to each
`
M
channel.
If the connected network camera that has configured the alarm in/out settings triggers an alarm, NVR will perform the alarm out.
`
Camera event
You can set the activation of events (motion detection, video analysis, audio event) sent from the camera, alarm
output method and alarm time.
• Apply to CH : If you select <Apply to Ch>, the "Apply to Ch" confirmation window will appear.
After selecting channels that the settings will be applied to, click on <OK> to apply them to the selected
channels.
• Camera Event : Select whether to use an event detection.
• MD : Select whether or not to use motion detection from camera.
• Cam : Select an event detection channel.
If you select a camera item, the "Camera preset" screen will appear. Select a channel to connect and set the
preset.
You can set the preset in PTZ mode.
`
• Alarm : Select the method for alarm output.
For more details, refer to "HDD alarm > Alarm". (Page 39)
`
• Alarm Duration : Set the duration of alarm.
• Camera MD : You can set the detailed setting of motion detection for a network camera connected.
- Mode : Set the motion detection mode.
- Area : Click on <Setup> and when the detailed setup menu appears, set the motion detection area.
- Sensitivity : Set the sensitivity for motion detection. (very low/low//medium/high/very high).
- Size : Click on <Setup>. When the detailed setup menu appears, set the max/min size of the object to be
detected.
- Activation Time : Select the operation time of motion detection.
After finishing with setup, click on the <OK> button to move back to the previous screen after saving the setup.
English _43