Samsung XRN-1610S User Manual page 46

menu setup
• Setting the DhCp Ip Address of the Broadband Router
1. To access the Broadband Router's configurations, open a web browser on the local PC that is connected
to the Broadband Router and enter the router's address (ex : http://192.168.1.1).
2. At this stage, make the local PC's windows network configurations to the below example :
Ex) IP : 192.168.1.2
Subnet Mask : 255.255.255.0
Gateway : 192.168.1.1
- Once connected to the Broadband Router, it prompts with password. While entering nothing to the User
Name field, enter "admin" into the password field and press <OK> to access the router configurations.
- Access the router's DHCP configuration menu and set its DHCP server activation, and provide the start
and end address.
Set the start address (192.168.0.100) and end address (192.168.0.200).
Above steps may differ from the router devices depending on the manufacturer.
`
M
port Setting
• Protocol Type : Select the protocol type among TCP, UDP - Unicast and UDP - Multicast.
• Device Port : Enter the connectable port number. Initially, <554> is set.
- TCP : It has better stability and lower speed when compared to UDP, and recommended for internet
environments.
• UDP Port : Initially, <8000~8159> is set. It increases / decreases by 160.
- UDP : It has less stability and faster speed when compared to TCP, and recommended for local area
network (LAN) environments.
• Multicast IP Address : User can directly input.
• Multicast TTL : Select from 0 ~ 255. Initial value for the TTL is set to <5>.
• HTTP Port : Enter the port number for the Web Viewer. Initially, it is set to <80>.
• Send SSL : Select this option to send SSL.
• Backup Bandwidth : Select the degree of backup bandwidth.
46_ menu setup
DDnS
If a remote user accesses the network, you can set whether or not to use DDNS and the site to be connected.
• DDNS Site : Specify the use of DDNS and select a site that you registered.
• Host Name : Provide the host name that you registered with the DDNS site.
• User Name : Provide the user ID that you registered with the DDNS Site.
• Password : Provide the password that you registered with the DDNS site.
Refer to "Using Virtual Keyboard". (Page 28)
`
M
If you select <OFF>, the input box will be inactive.
`
If you select <iPOLiS>, the host name input box will be inactive. The user name input box will be active.
`
• Quick Connect : Appears if the <samsungipolis.com> is selected for a <DDnS Site>.
To use the function, set to <use> after connecting the NVR to a UPnP router.
If canceled during Quick Connect configuration, it automatically switches to <Not Use> and saved.
`
M
to check Quick Connect status
A progress bar and its message appears for a Quick Connect.
• Quick Connect Success : Message for a successful connection.
• Invalid network Configuration : Message appears if the network configuration is not valid. Check the
configuration.
• please enable upnp function of the router : Message appears if the router requires UPnP function
enabled.
• Failed to find the router : Message appears if the router is not found. Check the router's configurations.
• please restart the router : Message appears if the router should be restarted.