Samsung XRN-1610S User Manual page 37

If the channel is set to <Covert1> or <Covert2> mode, the channel's sound is not hearable.
`
M
However, the channel's sound is recorded if its Audio setting is set to <ON>, even the sound is not heard in Live mode.
• Audio
- If set to <On>, you can turn the audio of the channel ON/OFF on the Live screen.
- If set to <OFF>, the channel's audio is off on the Live screen and not recorded.
• Camera Name : Provide a camera Name.
You can enter up to 15 characters including space.
`
Storage Device
You can check information on storage devices.
Device/Format
You can check storage devices and their capacity, usage as well as status.
HDD, E-SATA, iSCSI and USB (memory or HDD) can be connected as a storage device.
• Storage Status : Displays the working status of a storage device.
- Red : Displays the situation of video loss.
- Green : Displays the normal situation without video recording losses.
- Status
Total bps : Displays the current rate of recording.
`
Present Loss : Displays the current recording loss rate.
`
Worst Loss : Displays the maximum amount of losses up until now.
`
If the recording loss persists, please refer to the "Troubleshooting" in order to perform checks. (Page 78)
`
• No. : You can check the designated number for the built-in HDD.
If you want the find out about the location corresponding to the HDD number, refer to the <HDD Map>.
`
• Capacity : Displays the amount of storage device use and the full capacity.
• Usage : Designate the purpose of use for a storage device. (However, only the display function is available for
iSCSI and ARB)
• Status : Displays the current working condition of a storage device.
For inspection or replacement of HDD alarms, please refer to "hDD Alarm Setting." (Page 39)
- Normal : It is displayed during normal operation.
- Inspection : Operating with partial problems.
- Replacement : It is displayed when you can no longer use it.
• Temperature : You can check the temperature of the HDD mounted in the NVR.
• Time : Displays the use time of an HDD.
• Format : Select a device and click on format after which a format confirmation window appears.
Click on the <OK> button to format the selected storage device.
Formatting will delete all the recording data that has been saved. Be careful.
`
J
While formatting is ongoing, you cannot record video.
`
Do not remove a formatting device until it is finished.
`
• ARB : Video that was not recorded due to a camera disconnection can be backed up after the connection
with the camera is re-established. Press the button and an <Auto Recovery Backup> window is opened.
- ARB storage : Select a storage device to be set to ARB.
- ARB channel Selection : Select a channel to run the ARB.
You can select multiple channels.
`
If you select <All CHs>, all channels will be selected.
- ARB bandwidth : Select a bandwidth for the ARB function.
Only our camera products support the ARB function. The SD card recording function should be used.
`
M
To use the ARB function correctly, both the camera and NVR should be time synchronized with the time server. (Page 27)
`
ARB function is activated when NVR starts/when the channel camera set is reconnected/when an NVR recording missing
`
section recurs at regular intervals after NVR starts.
NVR recording missing section that can be restored with the ARB function is for 24 hours backwards from the point when the
`
ARB function is activated.
You can check which channels have ARB function activated through the message on each channel screen that is displayed
`
when selecting a channel. (Page 20)
• HDD Map : You can check the location according to the assigned number for the HDDs installed inside.
Refer to this when servicing or installing an additional HDD.
`
Do not add or remove an HDD while NVR is running.
`
J
English _37