Samsung XRN-1610S User Manual page 39

use Joystick
The SPC-2000 joystick is operated as follows:
d
Name
In PTZ mode, the camera can be panned, tilted, and controlled in 8 directions
Up/Down/Left/Right
The webviewer only supports the PTZ mode.
In Screen mode, the top/bottom/left/right tile can be selected.
a
In PTZ mode, the screen is zoomed in when it is rotated clockwise and zoomed out when it is rotated
Rotation
counterclockwise.
In PTZ mode, presets number 1~8 are run.
Screen mode works as follows.
1: Changing live layout / 2: Search
1~8
b
3: Backup / 4: Zoom mode
5: Freeze mode / 6: Audio
7: Alarm / 8: Rec
It allows to exit PTZ mode in PTZ mode.
9
The webviewer won't be able to stop the PTZ on its own.
This is used to change to PTZ mode from screen mode.
c
It allows to exit PTZ mode in PTZ mode.
10
The webviewer won't be able to stop the PTZ on its own.
In PTZ mode, Focus Near/Far operation is run.
11, 12
d
When using the screen mode, the same operations can be done by moving the mouse.
More than one mapped lun should be available to connect to the initiator when using lun mapping.
`
M
a
b
c
Function
hDD Alarm Setting
For HDD malfunctions, you can set the inspection alarm output terminal, the replacement alarm output
terminal, the iSCSI alarm output terminal and the alarm time.
• Alarm
- If <All> was selected, both beep sound and alarm signal through rear side ports will output.
- If <Beep> was selected, a beep will sound.
- Alarm signal will output through the alarm out port on the rear side when selected <1>, <2>, <3>, and <4>.
• Check Alarm Output Port : If HDD generates check alarm, the alarm signal will output to the specified alarm
output port.
• Replace Alarm Output Port : If HDD generates replace alarm, the alarm signal will output to the specified
alarm output port.
• iSCSI Alarm Output Port : If a connection to your iSCSI device is lost, a signal is sent to the designated alarm
terminal.
• Duration : Sets the alarm duration for the alarm signal and beep sound.
<Check> status means that the HDD is operating but it has problems that require technical examination.
`
M
( ) appears on the Live screen.
<Replace> status means that the HDD has defect and requires immediate replacement.
`
( ) appears on the Live screen.
Remote Devices
You can adjust the ID for a remote control to be used in connection with NVR.
• Remote control: Select whether to use a remote control.
• ID: Select an ID number linked to a remote control.
If the remote control ID does not match, it will not operate properly.
To change the remote control ID, refer to "Changing the Remote Control ID". (Page 8)
`
M
English _39