Event Setting - Samsung XRN-1610S User Manual

menu setup
• Password : Enter the password provided by the RADIUS server administrator.
If the password you entered does not match that of the client's private key, it won't be processed properly.
`
• Certificates : Search for a device. Click on <Rescan> to search for a device again.
• CA Certificate : Select this only if your public certificate includes the public key.
• Client Certificate : Select if the public certificate includes a client's authentication key.
• Client Private Key : Select it if the public certificate contains the client private key.
For successful implementation of the 802.1x operating environment, the administrator must use the RADIUS server.
`
M
In addition, the switch hub connected to the server must be a device that supports 802.1x.
If the time setting of the RADIUS server, the switch hub and an NVR device do not match, communication between them can
`
fail.
If a password is assigned to the client's private key, the server administrator should confirm the ID and password.
`
The ID and password allow up to 30 characters each. (But it only supports letters, numbers and special characters ("-", "_",
"." 3 types) only.
Accessing non password-protected files is allowed without entering a password.
The 802.1x protocol adopted by the NVR is EAP-TLS.
`
You need to install all three certificates to use 802.1x.
`
Live Streaming Setting
You can set the video profile transmitted to the network and the expansion monitor.
• Profile : Select a network profile for the connected camera.
• Codec : Show the codec information for the selected network profile.
• Resolution : Display the resolution for the selected network profile.
• Frame Rate : Display the frame rate for the selected network profile.
• Quality : Display the video quality for the selected network profile.
If the profiles used for network and recording are different, camera's video feed may not comply with the frame rate as
`
M
specified in the camera.
48_ menu setup
e-mail
You can send an e-mail to a NVR-registered user at a specific time interval, or if an event occurs.
Smtp Setting
Sets the SMTP mail server.
• Server Address : Enter the SMTP server address to connect to.
• Port : Sets the communication port.
• Use Authentication : Check this if the SMTP server uses user authentication.
The account input box will be activated.
• ID : Enter a ID to use authentication when connecting to the SMTP server.
• Password : Enter the password of the SMTP server user.
• Secure Transfer : Select one from <never> and <tLS (if available)>.
• Sender : Use the virtual keyboard to enter the sender's e-mail address.
Refer to "Using Virtual Keyboard". (Page 28)
`
• E-mail Test : Conducts the test on the server settings.

event Setting

You can set the interval and type of the event that will be sent to the user.
• Event Interval : Set the event interval.
If a series of events occurs, the e-mail will be sent at the specified interval, not on each event.
`
• Use Event Transfer : Select an event type to send if an event occurs.
If the selected event occurs, the e-mail will be sent to the group that has the recipient authority.