Samsung XRN-1610S User Manual page 80

appendix
Problem
In the recording setting screen, the permitted level
for a specific channel is displayed in orange.
In the live screen, the [ ] icon is displayed and
FULL NO the message window saying " recording data load RAID RAID SCSI
exceeds the limit. Check it in the record setting."
pops up.
Recording is not performed in accordance with the
settings.
The iSCSI disconnect icon and the error message
pop up window will appear.
The recording screen will slow down.
If recording loss persists continuously
Failed to recognize an E-SATA device.
80_ appendix
Action
y If the input data is greater than the permitted level for each channel, it is
displayed in orange. Set the permitted data limit to higher than the amount of
input data.
y If the sum of input data for each channel exceeds the limit, the alarm icon will
be displayed. In this case, the channel exceeding the input limit does not
record the entire frame, but it records the main frame only(one or two per
sec).
y If the sum of input data for each channel exceeds the limit, the alarm icon
and the pop up window will be displayed. In this case, the channel exceeding
the input limit does not record the entire frame, but it records the main frame
only(one or two per sec).
y Set the permitted data limit to higher than the amount of input data entered
in the record setting menu (page 41).
y If the recording status displays 'Exceeds the maximum hard disc
performance', set the recording size according to the recording performance
specifications for each HDD condition.
(Refer to "Record Settings" in the menu settings. (Page 41))
y Check if the iSCSI port is connected to the network cable.
y Check the IP address setting of the iSCSI equipment.
y Try a ping test.
y Check whether the recording performance specifications for each HDD
condition match the actual recording settings.
(Refer to "Record Settings" in the menu settings. (Page 41))
y If the data volume of a video exceeds the playing performance, only the main
frame is played.
(Refer to "Product Specifications" in the appendix. (Page 74))
y Reset the camera recording profile to let the entire recording bps size fit
the recording performance for each HDD condition. (Refer to "Record
Settings" in the menu settings. (Page 41))
Check the HDD status and determine whether inspection or replacement
`
is necessary.
(Refer to "Storage Device" in the menu settings. (Page 35))
y Please remove the power plug of the NVR and E-SATA, and then try
connecting them again.