Using Pcm+ To Update Switch Software - ProCurve 6200yl Management And Configuration Manual

File Transfers
Downloading Switch Software
Running Total
of Bytes
Downloaded
Figure A-8. Switch-To-Switch, from Primary in Source to Either Flash in Destination
A-22
For example, to download a software file from primary flash in a with an IP
address of 10.29.227.103 to the primary flash in the destination switch, you
would execute the following command in the destination switch's CLI:
Downloading from Either Flash in the Source Switch to Either Flash
in the Destination Switch.
Syntax: copy tftp flash < ip-addr > < /os/primary > | < /os/secondary > [ primary |
secondary ]
This command (executed in the destination switch) gives you
the most options for downloading between switches. If you do
not specify either a primary or secondary flash location for
the destination, the download automatically goes to primary
flash.
For example, to download a software file from secondary flash in a switch
with an IP address of 10.28.227.103 to the secondary flash in a destination
switch, you would execute the following command in the destination switch's
CLI:
Figure A-9. Switch-to-Switch, from Either Flash in Source to Either Flash in
Destination

Using PCM+ to Update Switch Software

ProCurve Manager Plus includes a software update utility for updating on
ProCurve switch products. For further information, refer to the Getting
Started Guide and the Administrator's Guide, provided electronically with
the application.