ProCurve 6200yl Management And Configuration Manual page 122

Switch Memory and Configuration
Using the Menu and Web Browser Interfaces To Implement Configuration Changes
N o t e
To save and
implement the
changes for all
parameters in this
screen, press the
[Enter] key, then
press [S] (for Save).
To cancel all
changes, press the
[Enter] key, then
press [C] (for Cancel)
N o t e
6-10
The only exception to this operation are two VLAN-related parameter changes
that require a reboot—described under "Rebooting To Activate Configuration
Changes" on page 6-11.
Using and
Save Cancel
For any configuration screen in the menu interface, the Save command:
1. Implements the changes in the running-config file
2. Saves your changes to the startup-config file
If you decide not to save and implement the changes in the screen, select
Cancel to discard them and continue switch operation with the current oper-
ation. For example, suppose you have made the changes shown below in the
System Information screen:
Figure 6-3. Example of Pending Configuration Changes You Can Save or Cancel
If you reconfigure a parameter in the CLI and then go to the menu interface
without executing a write memory command, those changes are stored only in
the running configuration (even if you execute a Save operation in the menu
interface). If you then execute a switch boot command in the menu interface,
the switch discards the configuration changes made while using the CLI. To
ensure that changes made while using the CLI are saved, execute write memory
in the CLI before rebooting the switch.
in the Menu Interface