ProCurve 6200yl Management And Configuration Manual page 267

1. Use the walkmib pethPsePortType.< slot-# > command to determine the MIB-
based port number for the port to which you want to assign a Configured
Type identifier. On the 5406zl switch the slot numbering is as follows:
Use the setmib pethPsePortType.< slot-# >.< port-# > -D < identifier-string >
2.
command to configure the identifier you want for a specific port.
For example, suppose that you have a PoE Module installed in slot B and want
to assign the identifier "Wireless-1" to port 1 in this slot. To do so, you would
use the following commands:
Power Over Ethernet (PoE) Operation
Slot Slot Number
Used in the MIB
A 1
B 2
C 3
D 4
E 5
F 6
Configuring PoE Operation
11-19