Switch-To-Switch Download - ProCurve 6200yl Management And Configuration Manual

File Transfers
Downloading Switch Software
A-20
3. When the copy finishes, you must reboot the switch to implement the
newly loaded software. To do so, use one of the following commands:
Syntax: boot system flash < primary | secondary >
Boots from the selected flash.
Syntax: reload
Boots from the flash image and startup-config file. A switch
covered in this guide (with multiple configuration files), also
uses the current startup-config file.
(For more on these commands, refer to "Rebooting the Switch" on page
6-18.)
4. To confirm that the software downloaded correctly, execute show system
and check the Firmware revision line.

Switch-to-Switch Download

You can use TFTP to transfer a software image between two switches of the
same series. The menu interface enables you to transfer primary-to-primary
or secondary-to-primary. The CLI enables all combinations of flash location
options.
Menu: Switch-to-Switch Download to Primary Flash
Using the menu interface, you can download a switch software file from either
the primary or secondary flash of one switch to the primary flash of another
switch of the same series.
1. From the switch console Main Menu in the switch to receive the down-
load, select 7. Download OS screen.
Ensure that the Method parameter is set to TFTP (the default).
2.
3. In the TFTP Server field, enter the IP address of the remote switch contain-
ing the software file you want to download.
For the Remote File Name, enter one of the following:
4.
• To download the software in the primary flash of the source switch,
type "flash" in lowercase characters.
• To download the software in the secondary flash of the source switch,
type
/os/secondary.