Table of Contents
Advertisement
N o t e
CLI: Viewing the Port and VLAN MAC Addresses
The MAC address assigned to each switch port is used internally by such
features as Flow Control and the spanning-tree protocol. Using the walkmib
command to determine the MAC address assignments for individual ports can
sometimes be useful when diagnosing switch operation.
Switch Series MAC Address Allocation
5400zl
The switch allots 24 MAC addresses per slot. For a given slot, if a
four-port module is installed, then the switch uses the first four MAC
addresses in the allotment for that slot, and the remaining 18 MAC
addresses are unused. If a 24-port module is installed, the switch
uses the first 24 MAC addresses in the allotment, and so-on.
3500yl
The switch allots 48 MAC addresses for the fixed ports and 4 MAC
addresses for the ports supported in the module slot.
6200yl
The switch allots 24 MAC addresses for the fixed ports and 4 MAC
addresses for the ports supported in the module slot.
All Models
The switch's base MAC address is assigned to VLAN (VID) 1 and
appears in the walkmib listing after the MAC addresses for the ports.
(All VLANs in the switch have the same MAC address.)
To display the switch's MAC addresses, use the walkmib command at the
command prompt:
This procedure displays the MAC addresses for all ports and existing VLANs
in the switch, regardless of which VLAN you select.
If the switch is at the CLI Operator level, use the enable command to enter
1.
the Manager level of the CLI.
2.
Type the following command to display the MAC address for each port on
the switch:
ProCurve# walkmib ifPhysAddress
(The above command is not case-sensitive.)
For example, on a 5406zl switch with the following module configuration
shows MAC address assignments similar to those shown in figure D-2:
■
a 4-port module in slot A, a 24-port module in slot C, and no modules in
slots B and D
two non-default VLANs configured
■
MAC Address Management
Determining MAC Addresses
D-5
Advertisement
Chapters
Table of Contents
Troubleshooting
