Displaying The Current Rate-Limit Configuration - ProCurve 6200yl Management And Configuration Manual

Hide thumbs Also See for 6200yl:

Table of Contents

Port Traffic Controls

Rate-Limiting

ProCurve Switch 5406zl(eth-A5)# show rate-limit all a1-a6

All-Traffic Rate Limit Maximum %

| Inbound Limit Mode

----- + ------------- --------- --------------- + -------------- ---------

You can configure a rate limit from either the global configuration level or

from the port context level. For example, either of the following commands

configures an inbound rate limit of 60% on ports A3 - A5:

ProCurve (config)# int a3-a5 rate-limit all in percent 60

ProCurve (eth-A3-A5)# rate-limit all in percent 60

Displaying the Current Rate-Limit Configuration

The show rate-limit all command displays the per-port rate-limit configuration

in the running-config file.

Syntax: show rate-limit all [ port-list ]

Without [ port-list ], this command lists the rate-limit

configuration for all ports on the switch. With [ port-list ], this

command lists the rate-limit configuration for the specified

port(s). This command operates the same way in any CLI

For example, if you wanted to view the rate-limiting configuration on the first

six ports in the module in slot "A":

Radius Override | Outbound Limit Mode

Figure 13-1. Example of Listing the Rate-Limit Configuration

Ports A1-A4 are configured with an

outbound rate limit of 200,000 bps (200 Kbps);

Port A5 is configured with an inbound rate

limit of 20%. (Port A6 is not configured for

rate-limiting.)

Table of Contents

5400zl 3500yl