Configuring Snmp Notification Support - ProCurve 6200yl Management And Configuration Manual

Configuring for Network Management Applications
LLDP (Link-Layer Discovery Protocol)
14-46
delay interval delays the port's ability to reinitialize and generate LLDP traffic
following an LLDP disable/enable cycle.
Syntax setmib lldpReinitDelay.0 -i < 1 - 10 >
Uses setmib to change the minimum time (reinitialization delay
interval) an LLDP port will wait before reinitializing after
receiving an LLDP disable command followed closely by a
txonly or tx_rx command. The delay interval commences with
execution of the lldp admin-status < port-list > disable command.
(Default: 2 seconds; Range: 1 - 10 seconds)
For example, the following command changes the reinitialization delay
interval to five seconds:
ProCurve(config)# setmib lldpreinitdelay.0 -i 5

Configuring SNMP Notification Support

You can enable SNMP trap notification of LLDP data changes detected on
advertisements received from neighbor devices, and control the interval
between successive notifications of data changes on the same neighbor.
Enabling LLDP Data Change Notification for SNMP Trap Receivers.
Syntax [ no ] lldp enable-notification < port-list >
Enables or disables each port in < port-list > for sending
notification to configured SNMP trap receiver(s) if an LLDP data
change is detected in an advertisement received on the port from
an LLDP neighbor. (Default: Disabled)
For information on configuring trap receivers in the switch, refer
to "SNMPv3 Notification and Traps" on page 14-17.
For example, this command enables SNMP notification on ports 1 - 5:
ProCurve(config)# lldp enable-notification 1-5