Overview - ProCurve 6200yl Management And Configuration Manual

Port Status and Configuration

Overview

Note On Connecting
Transceivers to
Fixed-Configuration
Devices
10-2
Overview
This chapter describes how to view the current port configuration and how
to configure ports to non-default settings, including
■ Enable/Disable
Mode (speed and duplex)
■
■ Flow Control
■ Broadcast Limit
Friendly Port Names
■
■ Uni-directional Link Detection (UDLD)
Viewing Port Status and Configuring Port
Parameters
Port Status and Configuration Features
Feature
viewing port status
viewing transceiver status
configuring ports
configuring ProCurve auto-mdix
If the switch either fails to show a link between an installed transceiver and
another device, or demonstrates errors or other unexpected behavior on the
link, check the port configuration on both devices for a speed and/or duplex
(mode) mismatch.
■ To check the mode setting for a port on the switch, use either the Port
Status screen in the menu interface (page 10-5) or show interfaces brief in
the CLI (page 10-7).
To display information about the transceivers installed on a switch, enter the
show tech receivers command in the CLI (page 10-10).
Default Menu
n/a page 10-5
n/a n/a
Refer to Table page 10-6
10-1 on pages
10-3 thru 10-4
CLI Web
page 10-7 page 10-18
page 10-10 page 10-18
page 10-12 page 10-18
page 9-11