ProCurve 6200yl Management And Configuration Manual page 370

Configuring for Network Management Applications
Using SNMP Tools To Manage the Switch
N o t e
14-26
IP-ADDR: The user-specified IP address that will be used as
the source IP address in the generated trap.
loopback <0-7>: The IP address configured for the specified
loopback interface will be used as the source IP address in
the generated trap pdu. In the case of multiple addresses, the
lowest alphanumeric address will be used.
The snmp-server response-source and snmp-server trap-source commands
configure the source IP address for IPv4 interfaces only.
The show snmp-server command displays the policy configuration:
ProCurve_5400(config)# show snmp-server
SNMP Communities
Community Name
---------------- -------- ------------
public
Trap Receivers
Link-Change Traps Enabled on Ports [All] : All
Send Authentication Traps [No] : No
Address
---------------------- ---------------- ------------------
-
Excluded MIBs
Snmp Response Pdu Source-IP Information
Selection Policy
Trap Pdu Source-IP Information
Selection Policy
Ip Address
Figure 14-11. An Example of Show SNMP-Server with Response Configuration
MIB View Write Access
Manager Unrestricted
| Community
: dstIpOfRequest
: Configured IP
: 10.10.10.10
Events Sent in Trap