Displaying The Current Rate-Limit Configuration - ProCurve 6400cl Management And Configuration Manual

Port Traffic Controls
All-Traffic Rate-Limiting for the 5300xl, 3400cl and 6400cl Switches
14-6
For example, either of the following commands configures an inbound rate
limit of 60% on ports A3 - A5:
ProCurve (config)# int a3-a5 rate-limit all 60
ProCurve (eth-A3-A5)# rate-limit all 60

Displaying the Current Rate-Limit Configuration

This command displays the per-port rate-limit configuration in the running­
config file.
Syntax: show rate-limit all [ port-list ]
Without [ port-list ], this command lists the rate-limit
configuration for all ports on the switch. With [ port-list ], this
command lists the rate-limit configuration for the specified
port(s). This command operates the same way in any CLI
context.
For example, if you wanted to view the rate-limiting configuration on the first
five ports in the module in slot "A":
Figure 14-1. Example of Listing the Rate-Limit Configuration
The show config command lists the per-port rate-limiting and Guaranteed
Minimum Bandwidth configuration in the startup-config file. (Note that con­
figuration changes performed with the CLI, but not followed by a write mem
command do not appear in the startup-config file.)
Ports A3-A5 are configured with a rate
limit of 60 %. (Ports A1 and A2 are not
configured for rate-limiting.)