Configuring Local Time Zone - Avaya 4000 Series Quick Start Configuration

4. Enter the following command to enable SNTP:
Variable definitions
The following table describes the parameters for the sntp server command.
<A.B.C.D>
<primary_server_ipv6address>
<secondary_server_ipv6address>

Configuring local time zone

About this task
Configure the time zone to use an internal system clock to maintain accurate time. The time
zone data does not include daylight changes. You need to configure daylight savings.
Procedure
1. Enter Global Configuration Mode in ACLI:
2. Enter the following command to enable SNTP:
3. Configure the time zone by using the following command:
4. Configure daylight savings using the following command:
Quick Start Configuration for Avaya ERS 4000 Series
sntp server secondary address [<A.B.C.D> |
<secondary_server_ipv6address>]
Note:
SNTP supports primary and secondary NTP servers. The system tries the
secondary NTP server only if the primary NTP server is unresponsive.
sntp enable
Variable
enable
configure terminal
sntp enable
clock time-zone zone hours [minutes]
Value
Enter the IP address of the NTP server.
Enter the IPv6 address of the primary NTP
server.
Enter the IPv6 address of the secondary NTP
server.
Configuring local time zone
November 2013 37