Configuring the switch using ACLI
Variable definitions
The following table describes the parameters for the clock source command.
ntp
sntp
sysUpTime
Configuring static route
Create static routes to manually configure a path to destination IP address prefixes.
Procedure
1. Enter the Global Configuration command mode:
2. Enable IP routing globally.
3. Configure IP address on a VLAN.
4. Configure a static route.
5. Display all the static routes.
6. Save the configuration.
Variable definition
Use the data in the following table to use the ip route command.
40
Quick Start Configuration for Avaya ERS 4000 Series
Variable
Configure NTP as time source
Configure SNTP as time source
Configure System Up Time as time source
enable
configure terminal
ip routing
ip address <ip address> <mask> [<MAC-offset>]
ip route <destination ip> <mask> <next-hop> {<cost> | disable
| enable | weight <cost>}
show ip route static [<dest-ip>] [-s <subnet> <mask>]
Comments? infodev@avaya.com
Value
November 2013