Configuring A Vlan - Avaya 4000 Series Quick Start Configuration

Configuring the switch using ACLI
For more information about the supported browsers, see Using ACLI and EDM on Avaya
Ethernet Routing Switch 4000 Series, NN47205-102
About this task
Monitor the switch through a Web browser from anywhere on the network. By default, the Web
interface uses a 15 minute time-out period. If no activity occurs for 15 minutes, the system logs
off the switch Web interface, and you must reenter the password information.
To configure inactivity time-out, see Configuring Systems on Avaya Ethernet Routing Switch
4000 Series, NN47205-500.
Procedure
1. Start your Web browser.
2. Type the switch IP address as the URL in the Web address field.
3. Enter the user name.
4. Enter the password.
5. Click Log On.

Configuring a VLAN

Use this procedure to create a VLAN using ACLI. Optionally, you can choose to assign the
VLAN a name.
For more information on configuring a VLAN, see Configuring VLANs, Spanning Tree, and
Multi-Link Trunking on Avaya Ethernet Routing Switch 4000 Series, NN47205-501.
Procedure
1. Enter Global Configuration mode:
2. To create a VLAN, enter the following command at the command prompt:
44 Quick Start Configuration for Avaya ERS 4000 Series
http://<IP Address>
https://<IP Address>
enable
configure terminal
vlan create <VID_list> [name <LINE>] type { port { voice-vlan
| remote-span | [<1-8>] { voice-vlan | remote-span } } |
protocol decEther2 | protocol-ipEther2 | protocol-ipv6Ether2
| protocol ipx802.2 | protocol-ipx802.3 | protocol-ipxEther2
| protocol ipxSnap | protocol-Netbios | protocol-RarpEther2 |
protocol sna802.2 | protocol-snaEther2 | protocol-vinesEther2
Comments? infodev@avaya.com
November 2013