Avaya 4000 Series Quick Start Configuration page 22

Connecting to the switch
8. Enter the IP address at the following prompt:
9. Enter the sub-net mask at the following prompt:
10. Enter the default gateway IP address at the following prompt:
11. Enter the read only community string at the following prompt:
12. Confirm the read only community string at the following prompt:
13. Enter the read write community string at the following prompt:
14. Confirm the read write community string at the following prompt:
15. Enter the VLAN ID for the Quick Start at the following prompt:
Example
Welcome to the 4548GT-PWR setup utility. You will be requested for information to
initially configure for the switch. When finished the information will be applied
and stored in the switch NVRAM. Once the basic parameters are configured, additional
configuration can proceed using other management interfaces.Press ^C to abort at any
time.
Please provide the in-band IP Address[0.0.0.0]:10.127.232.30
Please provide the in-band sub-net mask[0.0.0.0]:255.255.255.0
Please provide the Default Gateway[0.0.0.0]:10.127.232.1
Please provide the Read-Only Community String[**********]:******
Please confirm the Read-Only Community String[**********]:******
Please provide the Read-Write Community String[**********]:*******
Please confirm the Read-Write Community String[**********]:*******
Please provide the Quick Start VLAN <1-4094> [1]:
Basic switch parameters have now been configured and saved.
Important:
Avaya Ethernet Routing Switch 4000 Series only supports the Avaya CLI, the old Bay Stack
menu interface is not supported on this product. When the switch is set to factory default
parameters, the CLI Quickstart appears which enables you to set default IP information.
22 Quick Start Configuration for Avaya ERS 4000 Series
install
The ERS 4000 setup utility banner appears.
Please provide the in-band IP Address [0.0.0.0]:
Please provide the in-band sub-net mask [0.0.0.0]:
Please provide the Default Gateway [0.0.0.0]:
Please provide the Read-Only Community String [**********]:
Please confirm the Read-Only Community String[**********]:
Please provide the Read-Write Community String [**********]:
Please confirm the Read-Write Community String[**********]:
Please provide the Quick Start VLAN <1–4094> [1]:
Successful completion displays the following message:
Basic switch parameters have been configured and saved.
Comments? infodev@avaya.com
November 2013