Avaya 4000 Series Quick Start Configuration page 34

Configuring the switch using ACLI
Procedure
1. Enable Global Configuration mode in ACLI:
2. Enable Simple Network Management Protocol (SNMP) server.
3. Set the read-only community name.
4. Set the read-write community name.
5. Set the system name.
6. Set the system contact.
7. Set the location.
8. Configure SNMP host to add trap receiver to the trap-receiver table.
Variable definitions
Use the data in the following table to use the snmp-server name command.
34 Quick Start Configuration for Avaya ERS 4000 Series
enable
configure terminal
snmp-server enable
snmp-server community ro
Note:
Enter the community string two times.
If you have run the install script to set up the configuration information, the read-
only community name is already set.
snmp-server community rw
Note:
Enter the community string two times.
If you have run the install script to set up the configuration information, the read-
write community name is already set.
snmp-server name "<text>"
snmp-server contact "<text>"
snmp-server location "<text>"
snmp-server host <host-ip> <community-string>
Comments? infodev@avaya.com
November 2013