Avaya 4000 Series Quick Start Configuration page 35

Table 11: snmp-server name command
<text>
Use the data in the following table to use the snmp-server contact command.
Table 12: snmp-server contact command
<text>
Use the data in the following table to use the snmp-server location command.
Table 13: snmp-server location command
<text>
Use the data in the following table to use the snmp-server host command.
Table 14: snmp-server host command
<host-ip>
<community-string>
Quick Start Configuration for Avaya ERS 4000 Series
Variable
Variable
Variable
Variable
Configuring system identification
Value
Specifies the SNMP system name value.
Enter an alphanumeric string of up to 255
characters.
Note:
On the console, the SNMP server name is
truncated. On the Web interface, the full
SNMP server name appears.
Value
Specifies the SNMP system contact value.
Enter an ASCII string of up to 255
characters.
Value
Specifies the SNMP system location value.
Enter an alphanumeric string of up to 255
characters.
Value
Specifies an IPv4 or IPv6 address for a host
intended to be the trap destination.
If you are using the proprietary method for
SNMP, enter a community string that works
as a password and permits access to the
SNMP protocol.
November 2013 35