Avaya 4000 Series Quick Start Configuration page 56

Verification
Variable definitions
The following table describes the optional parameters you can enter with the show boot
[diag] [image] command.
Variable
diag
image
Important:
When the currently loaded and operational software status is displayed for a stack, the unit
number is replaced by the word All.
Displaying local alarms
View local alarms to monitor alarm conditions.
About this task
Local alarms are raised and cleared by applications running on the switch. Local alarms are
an automatic mechanism run by the system that do not require any additional user
configuration. The raising and clearing of local alarms also creates a log entry for each event.
Check alarms occasionally to ensure no alarms require additional operator attention.
Procedure
1. Enter Global Configuration Mode:
2. To display local alarms, enter the following command at the command prompt:
56 Quick Start Configuration for Avaya ERS 4000 Series
Displays only information for the agent load.
Displays only information for the image load.
enable
configure terminal
show rmon alarm
Comments? infodev@avaya.com
Value
November 2013