Table of Contents
Advertisement
A dialog saying "RECEIVE A CALL?" may appear on the
Control site monitor while the site is in communication with
a Remote site. This indicates that a new access is made by
another Remote site. The unit processes according to the
selection below.
RECEIVE A CALL?
IP ADDRESS:
N0.002
ACCEPT
REJECT
HOLD,CONTINUE CURRENT COM.
TERMINATE CURRENT COM.THEN ACCEPT
:MOVE ENT:EXEC
1. Move the cursor to one of the four options below with
the D or C button, then press the ENTER.
ACCEPT: The unit accepts the new access and holds
the current communication.
REJECT: The unit rejects the new access.
HOLD, CONTINUE CURRENT COM.: The unit holds
the new access until the current communication is
terminated.
TERMINATE CURRENT COM. THEN ACCEPT: The
unit terminates the current communication and
accepts the new access.
2. On-hold process
2-1 Press the SWITCH SITE (#3 of the one-touch dial)
button to display the on-hold list. The list shows
suspended callers (transmitter) with registered site
name or IP address respectively.
2-2 Move the cursor to a number you wish to communi-
cate with, then press the ENTER. Communication
will start.
SWITCH SITES?
NO.001
NO.002
192.168.0.20
:MOVE ENT:EXEC ESC:CLEAR
3. Hold down the DIAL button for 2 seconds to terminate
calls. The listed calls will be canceled and a message
"LINE TERMINATED" appears.
Note: When the call is terminated by the Remote site's
operation, "TERMINAL LEFT" appears on the
Control site monitor.
62
Trans.02
Trans.01
Trans.02
Alarm Operation
When a connected (alarm) sensor is activated on the
Remote site, the transmitter calls the Control sites to let
them check the alarm images. Alarm setups are made on
the Remote site in the menus 460 through 465.
When the Control site receives an alarm call, the ALARM
DIAL window appears.
VIDEO1
JAN.01.01 00:00:00
Trans.01
ALARM DIAL JAN.01.01 00:00:00
1. Press the ALM ACK button. The camera images asso-
ciated with the sensor is displayed on the Control site
monitor.
ONE TOUCH DIAL
1
2
STEP 1
DIAL
1
QUICK
4
7
PRESET
ESC
MENU
TELE
WIDE
2. To escape from the alarm display follow any one below
as the case may be.
• When AUTO DISC (automatic disconnection) is set
to OFF in the 461 ALARM SETUP menu, press the
ALM ACK button.
• When AUTO DISC is set to ON, the alarm display
ends as the preset timer elapses. You can press
the ALM ACK button before the preset timer elaps-
es.
ALARM
NO.1
Remote Controller WV-CU20
SWITCH
VIDEO
ALM ACK
1
3
4
5
SITE
AUTO/MANU
2
STEP 2
STEP 3
CALL
2
3
REDIAL
5
6
8
9
DELETE
SET
#
0
AUDIO MUTE
ENTER
AF
NEAR
FAR
Advertisement
Table of Contents
