Table of Contents
Advertisement
WJ-HD100 Digital Disk Recorder Control
Connections
1. Connect MONITOR OUT on the rear of the WJ-HD100 to AUX IN on the WJ-NT204 with a BNC attached coaxial cable.
2. Connect VIDEO IN on the rear of the WJ-HD100 to SPOT OUT on the WJ-NT204 with a BNC attached coaxial cable.
3. Connect DATA on the rear of the WJ-NT100 to DATA on the rear of the WJ-NT204.
4. Up to four (4) Combination cameras can be connected to the WJ-NT204.
OPERATE
SUSPEND
DAYLIGHT
SAVINGS
DATA
DATA
POWER
ON
OFF
Setup
1. On the ADMINISTRATOR SETUP PAGE, click the SERIAL PORT button to open the SERIAL PORT SETUP window. For
TYPE, select PS.Data. Select the same communication parameters as for the WJ-HD100.
2. On the ADMINISTRATOR SETUP PAGE, click the MODE SETUP button to open the MODE SETUP window.
3. Select either H.261 and JPEG in the MAIN PAGE DEFAULT MODE & INDEX FILE SELECT.
Then, select DIRECT COAX for CAM CONTROL.
Click the SET & REBOOT. The transmitter WJ-NT204 will restart.
Control Operation
Type in the location bar http://192.168.0.10/. The 192.168.0.10 in the URL may vary depending on the WJ-NT204 settings.
Type the identical address to that the WJ-NT204 is set to.
q
w
e
r
t
y
119
WJ-HD100
PUSH– PAUSE
SET
TIMER
HDD
MEMORY CARD
DISPLAY SELECT
/
STOP
PLAY
REC
/
ALARM
FULL
PLAY MODE SELECT
ALARM SEARCH
STEP
REW/FF
LOCK
/
/
VIDEO IN
MONITOR
OUT
SPOT OUT
AUX IN
LINK/
100
RING.VOL
10BASE-T
BASE-TX CONNECT
ACT
LOW
HIGH
Network Interface Unit WJ-NT
WJ-NT204
Note: Set DIP switch #3 on the rear of WJ-NT204 to ON.
PC
PC
LAN
u
PC
PC
i
o
Advertisement
Table of Contents
