Table of Contents
Advertisement
UTILITY SOFTWARE
Confirmation of the set values
Turn OFF all Mode Setup switches inside the WJ-NT204 front panel, and then press the RESET button to restart the unit.
Restarting makes the addresses entered take effect.
Perform a communication check by means of ping commands as follows.
q Connect the WJ-NT204 to the PC (see page 66).
w Click the [START] button on the PC, and then point to [Programs]. In the program menu, choose [MS-DOS Prompt], and
enter the following commands.
C: \Windows>ping 192.168.0.10
• The address has been set properly if the WJ-NT204 responds as follows:
Pinging 192.168.0.10 with 32 bytes of data :
Reply from 192.168.0.10 : bytes = 32 time < 10 ms TTL = 32
Reply from 192.168.0.10 : bytes = 32 time < 10 ms TTL = 32
Reply from 192.168.0.10 : bytes = 32 time < 10 ms TTL = 32
Reply from 192.168.0.10 : bytes = 32 time < 10 ms TTL = 32
• If the request times out without a response from the WJ-NT204, the address may not have been set properly. Attempt to
set it again.
Pinging 192.168.0.10 with 32 bytes of data :
Request timed out.
Request timed out.
Request timed out
Request timed out.
• If the WJ-NT204 responds as below, the network setup of the PC may be wrong. Correct the setup (e.g., change the IP
address to 192.168.0.2 and the sub netmask to 255.255.255.0), and enter the ping command again.
Pinging 192.168.0.10 with 32 bytes of data :
Destination host unreachable.
Destination host unreachable.
Destination host unreachable.
Destination host unreachable.
103
10BASE-T
100BASE-TX
crossover cable
WJ-NT204
(if the WJ-NT204 address is 192.168.0.10)
PC
Advertisement
Table of Contents
