Table of Contents
Advertisement
680 MODE DISP (display) [In Communication
Only]
Transmission and reception mode for audio and video can
be displayed in the communication status. Confirm that the
relevant modes are set appropriately.
1. Open the 680 MODE DISP menu.
680 MODE DISP.
SENDING MODE:
VIDEO : H261
AUDIO : G711-mu
RECEIVING MODE:
VIDEO : H261
AUDIO : G711-mu
ESC:PRV
2. Press the ESC button to return the window to the previ-
ous one.
690 INITIALIZE (In Standby Only)
INITIALIZE is to clear stored DIRECTORY or to return the
setup parameters to the default settings.
Warning:
The following are irrevocable procedures. We strongly rec-
ommend that you take notes necessary data before imple-
menting the INITIALIZE.
1. Open the 690 INITIALIZE menu.
690 INITIALIZE
SYSTEM
DIRECTORY : EXEC
:MOVE ENT:EXEC ESC:PRV
2. Move the cursor to SYSTEM or DIRECTORY, then press
the ENTER. The selected menu appears.
SYSTEM: All setups are reset to the default settings,
except the directory for quick dial.
DIRECTORY: Only the directory for dialing is reset.
51
0
kbps
128 kbps
: EXEC
3. When SYSTEM is selected, a message "(Do you want
to) INITIALIZE SYSTEM CONFIG?" appears.
INITIALIZE SYSTEM CONFIG?
PLEASE WRITE DOWN THE FOLLOWING
ADDRESSES BEFORE SELECTING YES
AND PRESSING ENT.
IP ADDRESS
SUBNET MASK
DEFAULT GATEWAY :
YES
NO
:SELECT ENT:EXEC ESC:PRV
3-1 Take notes the IP address, subnetmask and
default gateway following the message on the
screen.
3-2 Select YES or NO with the A or B button, then
press the ENTER.
YES: Returns the system setups to the default settings.
INITIALIZE is implemented!!
NO: No initializing, the menu goes back to 690 INITIAL-
IZE.
4. When DIRECTORY is selected, a message "(Do you
want to) CLEAR DIRECTORY REGI.?" appears.
CLEAR DIRECTORY REGI.?
IF SELECTING YES AND PRESSING ENT.
DIRECTORY WILL BE CLEAR.
YES
NO
:SELECT ENT:EXEC ESC:PRV
4-1 Read the message on the screen.
4-2 Select YES or NO with the A or B button, then
press the ENTER.
YES: Returns the dialing directory to the default set-
tings. INITIALIZE is implemented!!
NO: No initializing, the menu goes back to 690 INITIAL-
IZE.
: 192.168.
0. 10
: 255.255.255.
0
0.
0.
0.
0
Advertisement
Table of Contents
