Panasonic WJ-NT204 Operating Instructions Manual page 12

!0 Mode DIP Switch [MODE]
The default setting is marked with *.
After changing the DIP switch, make sure to turn OFF
the power switch once and then turn it ON, or press the
RESET button to take in the new settings to the unit.
ON
OFF
1 2 3 4 5 6 7 8 9 10
Bit # OFF
1 Normal Operation *
2 Normal Operation *
3 *
4 See below *
5 See below *
6 Normal Operation*
7 *
Setup Menu
8
Enabled *
9 RS-485 Rear
10 *
Initialize(1) will reset all settings including IP address back
to the factory default.
Initialize(2) will reset the HTML contents files back to the
factory default settings.
Initialize(3) will reset the IP address, subnet mask and
default gateway back to the factory default settings.
Applicable Line
OFF
OFF AUTO *
Bit #5
ON 100BASE-TX
12
ON Function/Note
Initialize(1) Maintenance
Initialize(2) HTML file
Not Used
Applicable Line
Applicable Line
Network
Initialize(3)
Configuration
Not Used
Menu Disabled Setup Menus
Host Port
RS-232C Front*
Selection
Not Used
Bit #4
ON
10BASE-T
AUTO