Table of Contents
Advertisement
MODE SETUP
On the ADMINISTRATOR SETUP PAGE, click the MODE SETUP button to display the MODE SETUP window.
Select set Operation mode, image quality and camera control.
q
w
e
q
MAIN PAGE DEFAULT MODE & INDEX FILE
SELECT
The following setting specifies the opening window you
access typing an IP address alone in the browser's
URL column.
MODE
Select a compression mode or enter the user's
index filename.
H.323/H.261: H.323/H.261 ITU-T is applied.
JPEG: Joint Photographic Experts Group is
applied.
User's index filename: Enter a filename.
CAM CONTROL
The rout for camera control is specified here
depending on the system composition. The follow-
ing selection for CONTROL is ignored if you
entered the index filename in the MODE procedure
right above.
PS . Data: Controls the cameras connected to an
auxiliary device (except WJ-NT204) capable of
PS . Data (Panasonic Security Data) protocol.
DIRECT COAXIAL: Controls the cameras directly
connected to the WJ-NT204 transmitter unit.
OTHERS: Select this for the case other than
PS . Data or DIRECT COAXIAL. This is applica-
ble to the WJ-SX550A/B or WJ-FS616 if con-
nected.
AUX SYSTEM CONTROL
You can specify auxiliary device(s) connected to
the WJ-NT204 transmitter. When there are more
than one device in the system, register them in the
PS . Data UNIT REGISTRATION window that is
opened from the SERIAL PORT window.
HD100: Digital Disk Recorder, WJ-HD100
HD500: Digital Disk Recorder, WJ-HD500
FS309/316/409/416: Video Multiplexer, WJ-FS309/
316/ 409/416
81
MP204: Data Multiplex Unit, WJ-MP204
SX550A/B: Matrix Switcher, WJ-SX550A/B
FS616: Video Multiplexer, WJ-FS616
NT204: Specify this when no auxiliary device con-
nected
Note: The Authorization window will appear when you
click on the SET & REBOOT for a new MODE set-
ting after once you set H.323/H.261.
Default Unit Address: The default unit address is set
to the selected device within 1-16.
SET & REBOOT: Settings are renewed to that you
have just made in the above procedures. Clicking
this button may interrupt communication among a
transmitter and a receiver or other PC.
w AUDIO MODE SELECT
This selection is available only when the H.261 is set in
the above selection. The transmitter sends audio data
complying with this selection. The default setting is
G.711-mu.
G.711-mu: Select this when the system is used in North
America or Japan.
G.711-A: Select this when the system is used in
Europe.
OFF: No sound is transmitted.
e H.261 VIDEO MODE SELECT
Bit rate and motion speed are set for the transmitter.
BIT RATE: 0 - 1024
When 0 is selected, no picture is transmitted. The
greater the bit rate (kbps) is, the more data is transmit-
ted. The default setting is 1024.
MOTION: The default setting is NORMAL.
IMAGE SIZE: Image size can be set to 640x480 or
352x288 when H.261 is selected. The default set-
ting is 352x288.
Advertisement
Table of Contents
