Section Overview; Safety Messages - Emerson Rosemount 3051 Reference Manual

Reference Manual
00809-0100-4797, Rev DA
Section 2
Section overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 3
Safety messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 3
Hazardous locations certifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 4
Configuration guidelines . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 4
Basic setup tasks . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 5
Detailed setup tasks . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 7
2.1

Section overview

This section contains information on commissioning the Rosemount
Transmitter with PROFIBUS
class two master.
2.2

Safety messages

Procedures and instructions in this section may require special precautions to ensure the
safety of the personnel performing the operations. Information that raises potential safety
issues is indicated by a warning symbol (
performing an operation preceded by this symbol.
Explosions could result in death or serious injury.
Installation of this transmitter in an explosive environment must be in accordance with the
appropriate local, national, and international standards, codes, and practices. Review the
approvals section of this Reference Manual for any restrictions associated with a safe
installation.
In an Explosion-Proof/Flameproof installation, do not remove the transmitter covers

when power is applied to the unit.
Process leaks may cause harm or result in death.
Install and tighten process connectors before applying pressure.

Electrical shock can result in death or serious injury.
Avoid contact with the leads and terminals. High voltage that may be present on leads

can cause electrical shock.
Configuration
Configuration
®
PA Protocol using either the local operator interface (LOI) or
). Refer to the following safety messages before
Configuration
August 2016
™
3051Pressure
3