Emerson Rosemount 3051 Reference Manual page 16

Configuration
August 2016
Each of these parameters can be set using,
LOI – see

Class two master – see

Pressure unit parameters
The LOI was designed to automatically set the following parameters when selecting a
Pressure Unit:
Measurement type: Pressure

Linearization: None

Scaling: None

See Flow or Level Configuration for defaults when configuring with the LOI.
Table 2-1. LOI Operation
Button
1.
Figure 2-2. LOI Menu
Note
See Appendix C: Local Operator Interface (LOI) Menu
list.
Pressure configuration using class two master
1. From the Basic Setup >> Units >> Primary Value >> Primary Value Type dropdown, select
Pressure.
2. Select units.
Note
Pressure units in steps 2a, 2b, and
using the LOI.
1. Measurement Type Pressure drives Linearization to None (Characterization >> Characterization Type >> No linearization) when down-
loaded to the device. Re-upload configuration to verify new Characterization Type.
6
Table 2-1 and Figure 2-2
Pressure configuration using class two master
Action Navigation
Moves down menu
Scroll
categories
Enter Select menu category
Characters flash when they can be changed.
1. ADDRESS
2. CALIBRATION
3. UNITS
4. DAMPING
5. DISPLAY
6. IDENTIFICATION #
7. EXIT
(1)
Character entry
Changes character
(1)
value
Enters character and
advances
ENTER into menu
ZERO
LOWER SENSOR
PRESSURE
UPPER SENSOR
FLOW
RESET FACTORY
LEVEL
TEMPERATURE
for a more detailed LOI menu and unit
2c must match. Set units in the Al Block in offline mode or
Reference Manual
00809-0100-4797, Rev DA
Save?
Changes between Save
and Cancel
Saves
1 - 126
Configuration