Emerson Rosemount 3051 Reference Manual page 194

®
PROFIBUS Block Information
August 2016
Table D-3. Analog input Block Parameters
Index Parameter name
1 ST_REV
2 TAG_DESC
3 STRATEGY
4 ALERT_KEY
5 TARGET_MODE
6 MODE_BLK
7 ALARM_SUM
8 BATCH
10 OUT
11 PV_SCALE
12 OUT_SCALE
13 LIN_TYPE
14 CHANNEL
16 PV_FTIME
17 FSAFE_TYPE
18 FSAFE_VALUE
19 ALARM_HYS
21 HI_HI_LIM
23 HI_LIM
25 LO_LIM
27 LO_LO_LIM
30 HI_HI_ALM
184
LOI
DTM name
location
Static Revision
N/A
No.
Tag N/A
Strategy N/A
Alert Key N/A
Target Mode N/A
Actual Mode N/A
Alarm Summary N/A
Batch
N/A
Information
Value (Output) N/A
PV Scale N/A
Output Scale N/A
Characterization
N/A
Type
Channel N/A
Filter Time
DAMP
Const
Fail Safe Mode N/A
Fail Safe Default
N/A
Value
Limit Hysteresis N/A
Upper Limit
N/A
Alarm Limits
Upper Limit
N/A
Warning Limits
Lower Limit
N/A
Warning Limits
Lower Limit
N/A
Alarm Limits
Upper Limit
N/A
Alarm
Definition
(1)
The revision level of the static data associated with block;
the revision value will be incremented each time a static
parameter value in the block is changed.
The user description of the intended block application.
Grouping of function blocks.
The identification number of the plant unit. This
information may be used in the host for sorting alarms,
etc.
Contains desired mode of the block normally set by the
operator or a control specification.
Contains the actual, permitted, and normal modes of the
block.
Contains the current states of the block alarms
Used in Batch applications according to IEC 61512-1
Value and status of the block output.
Conversion of the Process Variable into percent using the
high and low scale value, in TB.PRIMARY_VALUE_UNIT
The high and low scale values, units code, and number of
digits to the right of the decimal point associated with
OUT.
Linearization type
Used to select the Transducer Block measurement value.
Always 0x112.
The time constant of the first order PV filter. Time
required for a 63% change in the input value (seconds).
Defines the reaction of the device, if a fault is detected
Default value for the OUT parameter, in OUT_SCALE
units, if a sensor or sensor electronic fault is detected
The amount the alarm value must return within the
alarm limit before the associated active alarm condition
clears.
The setting of the alarm limit used to detect the HI HI
alarm condition.
The setting of the alarm limit used to detect the HI alarm
condition.
The setting of the alarm limit used to detect the LO alarm
condition.
The setting of the alarm limit used to detect the LO LO
alarm condition.
The HI Hi alarm data.
Reference Manual
00809-0100-4797, Rev DA
®
PROFIBUS Block Information