General Site Installation Guidelines For The Srx550 Services Gateway - Juniper SRX550 Hardware Manual

Related
Documentation

General Site Installation Guidelines for the SRX550 Services Gateway

Related
Documentation
Copyright © 2015, Juniper Networks, Inc.
Table 11: Site Preparation Checklist for SRX550 Services Gateway
Installation (continued)
Item or Task Additional Information
Plan the cable
routing and
management.
SRX550 Services Gateway Chassis on page 13
Installation Overview for the SRX550 Services Gateway on page 61
General Site Installation Guidelines for the SRX550 Services Gateway on page 37
The following precautions help you plan an acceptable operating environment for your
SRX550 Services Gateway and avoid environmentally caused equipment failures:
For the cooling system to function properly, the airflow around the chassis must be
unrestricted. Allow sufficient clearance between the front and back of the chassis and
adjacent equipment. Ensure that there is adequate circulation in the installation location.
Follow the ESD procedures to prevent any damage equipment. Static discharge can
cause components to fail completely or intermittently over time. For more information,
see "Preventing Electrostatic Discharge Damage to the SRX550 Services Gateway"
on page 166.
Ensure that the blank panels are installed into empty slots to prevent any interruption
or reduction in the flow of air across internal components.
NOTE: Install the services gateway only in restricted areas, such as dedicated
equipment rooms and equipment closets, in accordance with Articles 110–16,
110–17, and 110–18 of the National Electrical Code, ANSI/NFPA 70.
SRX550 Services Gateway Chassis on page 13
SRX550 Services Gateway Cabinet Size and Clearance Requirements on page 47
SRX550 Services Gateway Rack Size and Strength Requirements on page 43
Clearance Requirements for Airflow and Hardware Maintenance of the SRX550 Services
Gateway on page 44
Chapter 7: Planning and Preparing the Site
Performed
By Date Notes
37