Table 8: Srx550 Services Gateway Back Panel Components - Juniper SRX550 Hardware Manual

Copyright © 2015, Juniper Networks, Inc.

Table 8: SRX550 Services Gateway Back Panel Components

Number Component
1 Two power
supply slots.
Each power
supply contains a
power cord
outlet. One
645 W AC power
supply is
provided with the
services gateway.
2 ACE Slot
3 Grounding point
4 Storage slot
5 Electrostatic
discharge (ESD)
outlet
6 Air filter cover
Location Description
Left side of The power supply
back panel provides power to the
services gateway and its
components. When the
services gateway is
equipped with the two
power supply option,
they work together to
provide redundancy and
load-sharing.
The following power
supplies are available:
645 W AC power
supply with PoE
power
645 W DC power
supply with PoE
power
Top center NOTE: This slot is not
of the back used.
panel
Left side of Contains two M4 screws
the back that you use to connect
panel the grounding cable to
the services gateway
chassis.
Center of Slot where you can
the back install an extra data
panel, lower storage device.
edge
Right side Connector for an ESD
of the back wrist band.
panel
Right of the Provides access to the
back panel optional air filter.
NOTE: The air filter is
not currently orderable.
Chapter 3: Chassis Description
Usage
Power supplies are
hot-swappable and
support single- or
dual-redundant power
supply versions.
If you need to power
off the services
gateway after it
finishes booting, first
use the CLI to halt the
device.
Connects the services
gateway chassis to
earth ground.
Supplements the data
storage capacity of the
services gateway.
While working on the
services gateway, use
the ESD outlet to plug
in an ESD grounding
strap to prevent any
damage to the
services gateway.
The optional air filter
helps keep the
services gateway and
its components free
from dust particles.
The air filter is
hot-swappable.
NOTE: The air filter is
required for NEBS
compliance.
21