Command Prompts - HP procurve 8100fl series Management And Configuration Manual

N o t e

Command Prompts

The default configuration for your switch displays one of the following CLI
prompts:
ProCurve 8108fl#
ProCurve 8116fl#
To simplify recognition, this guide uses the hostname
command prompts for both models. For example:
ProCurve#
You can use the hostname command to change the text in the CLI prompt.
To configure an interface on the switch, you need to enter configuration mode
for that interface (for example, a physical port, LAG, or VLAN). The command
prompt display will vary according to the interface. Here are two examples:
ProCurve(config-interface-gig3/4)#
ProCurve(config-interface-vlan701)#
ProCurve(config-lag-13)#
This guide uses a generic prompt to represent commands that must be entered
from an interface configuration context:
ProCurve(config-if)#
Screen Simulations
Single lines of screen text and command output are represented like this:
ProCurve#show running-config
Screens containing more than one line of text and command output are shown
in table format like this:
ProCurve#show version
ProCurve Networking Switch 8100fl Series System Software
Version CY.02.02.0051
Copyright (c) 1998-2005 by ProCurve Networking.
Compiled on Sun Jan 22 20:20:26 PST 2006
Bootloader Version CY.02.02.0004
Switch uptime is 18 hours, 4 minutes, 28 seconds
...
Getting Started
Conventions
ProCurve
to represent
1-3