Saving And Using The New Configuration - HP procurve 8100fl series Management And Configuration Manual

Configuring Basic System Information and Port Parameters
Configuring Basic System Information
N o t e
4-8

Saving and Using the New Configuration

1. To activate the system commands entered in the previous steps, use the
following command:
ProCurve#save running-config
The CLI displays the following message:
ProCurve(config)#save running-config
Please wait, acquiring configuration lock...done in 0.00
seconds
Now activating configuration changes, status report will
be returned shortly.
ProCurve(config)#
0w0d: %SYS-7-CONFIG_RESULTS: 0 fail in 0 seconds
ProCurve(config)#
2. To display the running configuration, enter the following command:
ProCurve(config)#show running-config
Here is an example of displaying the running configuration:
ProCurve(config)#show running-config
interface GigabitEthernet1/1
no shutdown
ip address 10.16.100.2/30
interface GigabitEthernet1/2
interface GigabitEthernet1/3
interface GigabitEthernet1/4
interface Loopback0
ip address 10.16.130.4/32
ProCurve 8100fl ospf 1
network 10.16.0.0 0.0.255.255 area 10.16.0.0
ip route 10.200.0.0/16 10.203.255.254
ip route 10.201.0.0/16 10.203.255.254
!
end
ProCurve(config)#
For more details on interacting with configuration files, see
Configuration Files" on page 3-2.
"Maintaining