Configuring Mst Instance Parameters - HP procurve 8100fl series Management And Configuration Manual

Spanning-Tree Operation
Configuring MSTP
9-22

Configuring MST Instance Parameters

The commands in this section apply on the switch level, and do not affect
individual port configurations. Those commands listed as belonging to the
spanning tree instance context must be entered within the instance
configuration context. For example, to map a VLAN to a spanning tree
instance, you must first enter the appropriate instance configuration mode
before you can map the member-vlan <vid> to that instance. For example, to
map VLAN 15 to spanning tree instance 2, you would enter:
ProCurve(config)# spanning tree instance 2
Enters configuration context for spanning-tree instance 2.
ProCurve(config-mst)#member-vlan 15
Maps VLAN 15 to spanning tree instance 2.
Configuration Context
Global Configuration:
ProCurve (config)#
Global Configuration:
ProCurve (config)#
Spanning Tree Instance:
ProCurve (config-mst)#
Spanning Tree Instance:
ProCurve (config-mst)#
Syntax: [no] spanning-tree instance < 1..16 >
This command creates a new MST instance (MSTI). You can create
up to 16 MSTIs in a region. The no form of the command deletes the
specified MSTI.
Note: Configuring MSTP on the switch automatically configures the
IST instance and places all statically configured VLANs on the switch
into the IST instance. For details on mapping a VLAN to a specific
spanning tree instance, see the member-vlan command on page 9-23.
Command
[no] spanning-tree instance < 0..16 >
spanning-tree priority < 0..15 >
[no] member-vlan < vid>
spanning-tree priority < 0..15 >
Page
below
9-24
9-23
9-24