Configuring a VLAN
This section shows you how to create a VLAN and assign ports.
Creating a VLAN
The 8100fl switch supports standards-based VLAN trunking between multiple
8100fl switches as defined by IEEE 802.1Q. 802.1Q adds a header to a standard
Ethernet frame. These VLAN IDs extend the VLAN broadcast domain to more
than one switch.
■
To create a VLAN, enter the following command in Configuration mode:
ProCurve(config)#vlan <ID>
To create a range of VLANs, enter the following command in Configura
■
tion mode:
ProCurve(config)#vlan <number range>
To set the VLAN aging time, enter the following command in VLAN
■
Configuration mode.
ProCurve(config-vlan)#aging <aging-time>
For example, to set VLAN 229 aging time to 30 seconds, enter
ProCurve(config)#vlan 229
ProCurve(config-vlan-229)#aging 30
■
To assign a name and description to the specified VLAN, enter the follow
ing commands in VLAN Configuration mode.
ProCurve(config-vlan-229)#name <string>
ProCurve(config-vlan-229)#description <string>
■
To set the Maximum Transmission Unit (MTU) size on this VLAN, enter.
ProCurve(config-vlan-229)#mtu <mtu-val>
VLAN Configuration
Configuring a VLAN
6-5