HP procurve 8100fl series Management And Configuration Manual page 57

N o t e
N o t e
N o t e
To limit the amount of time (in minutes) that a session on this line can
■
remain connected without activity, enter:
ProCurve(config-line)#exec-timeout <value>
where value is an integer designating the timer inactivity in minutes (enter
a value of 0 to set an unlimited time for each session).
■ To configure the system to perform local password checking on this line,
enter:
ProCurve(config-line)#login-authentication <method-list>
To use the default authentication list (instead of a named method list),
enter login authentication default.
To configure authorization for this line:.
■
ProCurve(config-line)#authorization {commands level |
exec} method-list
To configure the terminal length (in lines) for this terminal line:.
■
ProCurve(config-line)#length <value>
Setting the length to 0 disables auto-pager.
To configure the terminal width in characters for this line:.
■
ProCurve(config-line)#width <value>
To configure a password that users must enter to gain access to this line:
■
ProCurve(config-line)#password {[0] cleartext-pw | 5
hidden-pw}
where 0 indicates a permanently unencrypted password, 5 indicates an
encrypted password.
For more information on setting up prompts and passwords for your
switch, see "Configuring Passwords" on page
Configuring Basic System Information and Port Parameters
Configuring Basic System Information
5-2.
4-7