Enabling/Disabling Mib Modules - HP procurve 8100fl series Management And Configuration Manual

SNMP Configuration
Configuring Access to MIB Objects
ProCurve(config)#snmp mib ?
entity-mib
if-mib
ip-forward-mib
ip-mib
hp-switch-fl-series-inventory-mib
snmpv2-mib
tcp-mib
version 4 per RFC 2012
udp-mib
per RFC 2013
18-8

Enabling/Disabling MIB Modules

All MIB modules are enabled (or online) by default. Use the snmp mib ?
command to display supported MIBs. For this release, the 8100fl switch
supports the following MIBs:
- rfc2737 specific system details
- Interface status and generic counters per RFC 2863
- IPv4 CIDR forwarding database per RFC 2096
- Counters for IP and ICMP version 4 per RFC 2011
- System detail, SNMPv1/v2c/v3 counters per RFC 1907
- Counters for Transmission Control Protocol, IP
- Counters for User Datagram Protocol, IP version 4
All MIB modules can be accessed by SNMP management stations that provide
the correct community strings. You may want to provide access to a smaller
set of MIB modules. To do so, you can "disable" MIB modules by using the no
snmp mib command as shown in the following example:
ProCurve(config)#no snmp mib hp-switch-fl-series-inventory-
mib
You can then view the MIB modules, including their status, as shown in
"Displaying SNMP Information" on page
- HP switch inventory details
18-9.