Access Control Lists (ACLs)
Layer 2 Access Control Lists (ACLs)
15-14
To apply a Layer 2 ACL to a specified VLAN interface on input, enter the
following command:
ProCurve(config-if)#l2acl [police | <aclname>] vlan <vlanid>
in
For example, to apply an ACL called 303 for traffic inbound to VLAN 220, you
would enter;
ProCurve(config)#interface gig 4/3
ProCurve(config-if)#l2acl 303 vlan 220 in
Monitoring Layer 2 ACLs
Use the following commands to display information on Layer 2 ACLs.
Table 15-2. Monitoring Layer 2 ACLs
Command
show l2acl
show l2acl <name>
show l2acl resource-usage slot <number>
The following is an example of the display from the acl show all command
shows resource usage by interface module 1:
ProCurve#show l2acl resource-usage interface-module 1
###########################################################
L2 Rules=13, L3 Rules=4, Available=1007, Max=1024
###########################################################
Action
Show all L2 ACLs
Show the specific L2 ACL
Show the impact on resource usage of L2
ACLs