HP procurve 8100fl series Management And Configuration Manual page 252

Time Configuration
Using NTP
ProCurve(config)#show ntp associations
remote
========================================================================
*10.200.1.2
=10.200.1.5
ProCurve(config)#show ntp status
system peer:
system peer mode:
leap indicator:
stratum:
precision:
root distance:
root dispersion:
reference ID:
reference time:
system flags:
jitter:
stability:
broadcastdelay:
authdelay:
N o t e
17-4
The following example shows a typical configuration of NTP servers. (The *
symbol indicates the ip address of the server the switch is synchronized
against, the = symbol identifies an additional ntp server.) Use the detail
parameter to display all of the NTP statistics.
local st
10.203.11.27 3
10.203.11.27 3
The following example shows the NTP status of the system synchronized at
10.200.1.2:
10.200.1.2
client
00
4
-18
0.08955 s
0.09282 s
[10.200.1.2]
c21144bd.7e63736c Thu, Mar 6 2003 3:53:33.493
monitor ntp kernel stats pps
0.000397 s
1.837 ppm
0.003998 s
0.000000 s
If your switch is not synchronized, the NTP status will not display.
poll reach delay
64 377 0.00031
64 377 0.00029
offset disp
0.024771 0.00006
0.030663 0.00012