Layer 2 Filters; Configuring Layer 2 Address And Port-To-Address Lock Filters - HP procurve 8100fl series Management And Configuration Manual

IP Routing Configuration

Layer 2 Filters

11-6

Layer 2 Filters

Layer 2 filters on the 8100fl switch allow you to configure ports to filter specific
MAC addresses. When defining a Layer 2 filter, you specify the ports to which
you want the filter to apply. You can specify the following filters:
Address filters. These filters block traffic based on the frame's source MAC
address, destination MAC address, or both source and destination MAC
addresses in flow bridging mode. Address filters are always configured and
applied to the input port.
Port-to-address lock filters. These filters prohibit a user connected to a
locked port or set of ports from using another port.
Configuring Layer 2 Address and Port-to-Address Lock
Filters
If you want to control access to a source or destination on a per-MAC address
basis, you can configure an address filter. Address filters are always
configured and applied to the input port. You can set address filters on a source
MAC address, which filters out any frame coming from a specific source MAC
address
To configure Layer 2 address filters, enter the following commands in
Configuration mode:
ProCurve(config)#l2filter <name> lock <MACaddr> vlan <VLAN-
num> in-port-list <port-list> interface <interface-slot-
port>