Configuring Optional Parameters For The Nqa Operation - HP 5920 Configuration Manual

Step
7. Specify the source IP address of
ICMP echo request.
8. Specify the number of ICMP
echo requests to be sent in a
path jitter operation.
9. Specify the interval for sending
ICMP echo requests.
10. Specify how long the NQA
client waits for a response from
the server before it regards the
response times out.
11. (Optional.) Specify an LSR path.
12. (Optional.) Perform the path
jitter operation on destination
only.

Configuring optional parameters for the NQA operation

Unless otherwise specified, the following optional parameters apply to all types of NQA operations.
To configure optional parameters for an NQA operation:
Step
1. Enter system view.
2. Create an NQA
operation and enter NQA
operation view.
3. Specify an NQA
operation type and enter
its view.
4. (Optional.) Configure a
description.
Command
source ip ip-address
probe packet-number
packet-number
probe packet-interval
packet-interval
probe packet-timeout
packet-timeout
lsr-path ip-address&<1-8>
target-only
Command
system-view
nqa entry admin-name
operation-tag
type { dhcp | dlsw | dns | ftp |
http | icmp-echo | path-jitter |
snmp | tcp | udp-echo |
udp-jitter | voice }
description text
134
Remarks
By default, no source IP address is
specified.
The source IP address must be the IP
address of a local interface and the
interface must be up.
The default setting is 10.
The default setting is 20 milliseconds.
The default setting is 3000
milliseconds.
By default, no LSR path is specified.
The path jitter operation uses the
tracert to detect the LSR path to the
destination, and sends ICMP echo
requests to each hop on the LSR.
By default, the path jitter operation is
performed on each hop on the path
to the destination.
Remarks
N/A
By default, no NQA operation is created.
N/A
By default, no description is configured.