HP 5920 Configuration Manual page 282

Operation Description
Creates a specified target. To
use the create attribute in the
edit-config operation, you must
specify the operation target.
•
edit-config: create
•
Replaces the specified target.
•
edit-config:
replace
•
Removes the specified
configuration.
•
•
edit-config:
remove
•
If the table supports target
creation and the specified
target does not exist, the
operation creates and then
configures the target.
If the specified target exists,
a data-exist error message is
returned.
If the specified target exists,
the operation replaces the
configuration of the target
with the configuration
carried in the message.
If the specified target does
not exist, the operation is not
conducted and an
invalid-value error message
is returned.
If the specified target has
only the table index, the
operation removes all
configuration of the
specified target, and the
target itself.
If the specified target has the
table index and
configuration data, the
operation removes the
specified configuration data
of this target.
If the specified target does
not exist, or the XML
message does not specify
any target, a success
message is returned.
272
XML example
The XML data format is the same as the edit-config
message with the merge attribute. Change the
operation attribute from merge to create.
The syntax is the same as the edit-config message with
the merge attribute. Change the operation attribute
from merge to replace.
The syntax is the same as the edit-config message with
the merge attribute. Change the operation attribute
from merge to remove.