Displaying The Snmp Settings; Snmpv1/Snmpv2C Configuration Example - HP 5920 Configuration Manual

Step
7. (Optional.) Configure
the interval for sending
periodical traps.

Displaying the SNMP settings

Execute display commands in any view. The display snmp-agent community command is supported only
in non-FIPS mode.
Task
Display SNMP agent system information, including
the contact, physical location, and SNMP version.
Display SNMP agent statistics.
Display the local engine ID.
Display SNMP group information.
Display remote engine IDs.
Display basic information about the notification
queue.
Display the modules that can generate notifications
and their notification status (enable or disable).
Display SNMPv3 user information.
Display SNMPv1 or SNMPv2c community
information. (This command is not supported in FIPS
mode.)
Display MIB view information.
Display SNMP MIB node information.
Display an SNMP context.

SNMPv1/SNMPv2c configuration example

SNMPv1 configuration procedure is the same as the SNMPv2c configuration procedure. This example
uses SNMPv1, and is available only for non-FIPS mode.
Command
snmp-agent trap periodical-interval
interval-time
104
Remarks
By default, the SNMP agent sends
a periodical trap every 60
seconds.
This configuration is available in
Release 2311P04 and later
versions.
Command
display snmp-agent sys-info [ contact | location |
version ]
display snmp-agent statistics
display snmp-agent local-engineid
display snmp-agent group [ group-name ]
display snmp-agent remote [ ip-address
[ vpn-instance vpn-instance-name ] | ipv6
ipv6-address [ vpn-instance vpn-instance-name ] ]
display snmp-agent trap queue
display snmp-agent trap-list
display snmp-agent usm-user [ engineid engineid |
username user-name | group group-name ] *
display snmp-agent community [ read | write ]
display snmp-agent mib-view [ exclude | include |
viewname view-name ]
display snmp-agent mib-node [ details | index-node
| trap-node | verbose ]
display snmp-agent context [ context-name ]