Configuring A Remote Source Group On The Source Device - HP 5920 Configuration Manual

Step
3. Assign the port to the probe VLAN.
For more information about the port access vlan, port trunk permit vlan, and port hybrid vlan commands,
see Layer 2—LAN Switching Command Reference.

Configuring a remote source group on the source device

Creating a remote source group
Step
1. Enter system view.
2. Create a remote source
group.
Configuring source ports for a remote source group
You can configure a list of source ports for a mirroring group at a time in system view, or assign a port
to it as a source port in interface view. To assign multiple ports to a mirroring group as source ports in
interface view, repeat the operation.
When you configure source ports for a remote source group, follow these restrictions and guidelines:
Do not assign a source port to the remote probe VLAN.
•
• A mirroring group can contain multiple source ports.
A port can act as a source port for multiple mirroring groups. A port cannot be a reflector port,
•
monitor port, or an egress port at the same time.
To configure source ports for a remote source group in system view:
Step
1. Enter system view.
2. Configure source ports for the
specified remote source
group.
To configure a source port for a remote source group in interface view:
Step
1. Enter system view.
2. Enter interface view.
Command
•
For an access port:
port access vlan vlan-id
•
For a trunk port:
port trunk permit vlan vlan-id
•
For a hybrid port:
port hybrid vlan vlan-id { tagged | untagged }
Command
system-view
mirroring-group group-id remote-source
Command
system-view
mirroring-group group-id
mirroring-port interface-list { both |
inbound | outbound }
Command
system-view
interface interface-type
interface-number
181
Remarks
N/A
By default, no remote source
group exists on a device.
Remarks
N/A
By default, no source port is
configured for a remote source
group.
Remarks
N/A
N/A